Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference page 38

Ausm software
Hide thumbs Also See for MGX 8850 PXM1E:
Table of Contents

Advertisement

Quickstart Provisioning Procedures
To configure an SPVC between an AUSM card and a non-AUSM card, perform the following steps:
Command
Step 1
username
<password>
Step 2
Refer to the software configuration
guides for the switches between the
two AUSM cards to be connected.
See the Cisco MGX 8850 (PXM1E)
and MGX 883Cisco MGX 8850
(PXM1E) and MGX 8830 Software
Configuration Guide, Release 3 and
the Cisco MGX 8850 (PXM45) and
MGX 8950 Software Configuration
Guide, Release 3.
Step 3
See the
Quickstart"
Group Configuration Quickstart"
section, both of which appear earlier
in this chapter.
Step 4
addcon <options>
Related commands:
dspcons
dspcon <port.DLCI>
Step 5
addcon <options>
Related commands:
dspcons
dspcon <port.DLCI>
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
2-6
"ATM Port Configuration
section or the
"IMA
Chapter 2
Purpose
Start a configuration session.
Note
To perform all the steps in this quickstart procedure, you
must log in as a user with GROUP1 privileges or higher.
Configure the trunks that link the switch(es) that host(s) the
ATM ports or IMA groups.
Verify PNNI connectivity between the nodes that host the SPVC
endpoints.
Configure the ATM port or IMA group at the AUSM end of the
SPVC you are creating.
Configure the slave side of the SPVC (if you are configuring a
double-ended SPVC).
If the slave side of the connection is on the AUSM card, see the
"Configuring SPVCs on AUSM Cards"
in this chapter.
If the slave side of the connection is on a non-AUSM card, refer
to the documentation for that card.
Configure the master side of the SPVC.
Note
In this release, the AUSM cards cannot host the master
side of a single-ended SPVC.
If the master side of the connection is on the AUSM card, see the
"Configuring SPVCs on AUSM Cards"
in this chapter.
If the master side of the connection is on a non-AUSM card,
refer to the documentation for that card.
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Provisioning Communications Links
section that appears later
section that appears later

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mgx 8830

Table of Contents