Table of Contents
Advertisement
Chapter 2
Provisioning Communications Links
To configure an SPVC between two AUSM ATM ports or IMA groups (on the same card in a switch, on
different cards in the same switch, or on cards in different switches), perform the following steps:
Command
Step 1
username
<password>
Step 2
Refer to the software configuration
guides for the switches between the
two AUSM cards to be connected.
See the Cisco MGX 8850 (PXM1E)
and MGX 883Cisco MGX 8850
(PXM1E) and MGX 8830 Software
Configuration Guide, Release 3 and
the Cisco MGX 8850 (PXM45) and
MGX 8950 Software Configuration
Guide, Release 3.
Step 3
See the
Quickstart"
Group Configuration Quickstart"
section, both of which appear earlier
in this chapter.
Step 4
addcon <options>
Related commands:
dspcons
dspcon <port.DLCI>
Step 5
addcon <options>
Related commands:
dspcons
dspcon <port.DLCI>
AUSM-to-Non-AUSM SPVC Configuration Quickstart
When creating an SPVC between a AUSM card and a non-AUSM card (such as a FRSM, RPM, or AXSM
card), you must define both ends of the connection, just as you would for an AUSM-to-AUSM
connection. The difference is that you will have to refer to the documentation for the non-AUSM product
for information on configuring the connection endpoint.
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
"ATM Port Configuration
section or the
"IMA
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
Purpose
Start a configuration session.
Note
To perform all the steps in this quickstart procedure, you
must log in as a user with GROUP1 privileges or higher.
Configure the trunks that link the switch(es) that host(s) the
AUSM card ports.
Verify PNNI connectivity between the nodes that host the SPVC
endpoints.
Configure the ATM port or IMA group at each end of the SPVC
you are creating.
Configure the slave side of the SPVC (if you are configuring a
double-ended SPVC).
See the
"Configuring SPVCs on AUSM Cards"
appears later in this chapter.
Configure the master side of the SPVC.
Note
In this release, the AUSM cards cannot host the master
side of a single-ended SPVC.
See the
"Configuring SPVCs on AUSM Cards"
appears later in this chapter.
Quickstart Provisioning Procedures
section that
section that
2-5
Advertisement
Table of Contents
