Chapter 2
Provisioning Communications Links
Table 2-7
Parameter
-ct
-contp
-st
-master
-rmc
-abrtype
-abrpcr
-abrmcr
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Parameters for the addcon Command (continued)
Description
Enter a connection type:
VCC = 0
•
VPC range = 1 to 1000
•
Controller type. Select one of the following:
•
1 = PAR
•
2 = PNNI (default)
3 = MPLS
•
Service class type. Select one of the following service types:
CBR = 1 (default)
•
•
CBR1 = 21
•
CBR2 = 31
•
CBR3 = 32
rtVBR = 5
•
rtVBR1 = 22
•
rtVBR2 = 23
•
rtVBR3 = 24
•
nrtVBR = 2
•
•
nrtVBR1 = 25
•
nrtVBR2 = 26
•
nrtVBR3 = 27
•
ABR = 3
•
UBR = 4
UBR1 = 28
•
UBR2 = 29
•
Mastership role of connection. Select from the following options:
1 = master
•
•
2 = slave (default)
Remote connection ID. This option is used when defining the master end of a
connection. Enter the slave connection ID as it appears after the addcon command
is issued. The format is: RemoteNsapAddress.VPI.VCI.
ABR connection behavior type:
Switch behavior = 1
•
Source/destination behavior = 2
•
Peak cell rate for ABR connections. The range is 10 to 38328 cps.
Minimum cell rate for ABR connections. The range is 10 to 38328 cps.
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
General AUSM Provisioning Procedures
2-17