Managing Ports
PXM1E_SJ.1.1.AUSMB8.a > dspport 1
IMA Group number
Port type
Lines configured
Enable
IMA Port state
IMA Group Ne state
PortSpeed (cells/sec)
GroupTxAvailCellRate (cells/sec) : 14364
ImaGroupTxFrameLength(cells)
LcpDelayTolerance (IMA frames)
ReadPtrWrPtrDiff
Minimum number of links
MaxTolerableDiffDelay (msec)
Lines Present
Observed Diff delay (msec)
Clock Mode
GroupAlpha
GroupBeta
GroupGamma
GroupConfiguration
IMAGrp Failure status
Timing reference link
ImaGroupTxImaId
ExpectedGroupRxImaId
PXM1E_SJ.1.1.AUSMB8.a >
Deleting Ports
To delete an AUSM port, use the following procedure.
You cannot use the delport command to delete a port number used by an IMA group. To delete an IMA
Note
group, use the delimagrp command.
Delete all connections that are associated with the port (dspcons and delcon commands).
Step 1
Delete all resource partitions that are associated with the port (delrscprtn command).
Step 2
Step 3
Enter the delport command, as shown below.
PXM1E_SJ.1.1.AUSMB8.a > delport <port>
Replace the port parameter with the port number you want to delete. Port numbers are listed in the
dspports command display.
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
3-8
: 1
: NNI
: 1.2.3.4
: Modify
: Active
: operational
: 14364
: 128
: 1
(cells)
: 4
: 2
: 275
: 1.2.3.4
: 0
: CTC
: 2
: 2
: 1
: 1
: No Failure
: 1
: 0x0
: 0x1
Chapter 3
AUSM Card Management
Release 3, Part Number 78-14254-01 Rev. A0, October 2002