Dspchans - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

Chapter 4 AUSM Command Reference

dspchans

Display Channels
Use the dspchans command to display a summary of all the connections on the current AUSM card.
There are no required parameters for this command. The command options allow you to customize the
report the command displays.
Syntax
dspchans [-h] [-chn <ChanNum>] [-pt <PortNum>] [-vpi <VPI>] [-vci <VCI>] [-cos <ConnServType>]
[-ct <ConnectionType>] [-master <masterShip>] [-pqn <Qnum>] [-admin <ConnAdminStatus>]
[-alarm <ConnAlarmStatus>]
Syntax Description
-h
-chn
-pt
-vpi
-vci
-cos
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Display the list of command options.
Channel number. Use this option to limit the display to a specific channel. To
view the configured channel numbers, use the dspcons command without any
options.
Port number. This option limits the display to the connections on the specified
port. To view the configured ports, use the dspports command.
Connection VPI number. This option limits the display to the connections that
use the specified VPI number. To view the configured VPI numbers, use the
dspcons command without any options.
Connection VCI number. This option limits the display to the connections that
use the specified VCI number. To view the configured VCI numbers, use the
dspcons command without any options.
Service type. Use this option to limit the display to connections that use a
particular ATM service type. To select the service type, enter the option with
one of the following keywords:
CBR1
•
CBR2
•
CBR3
•
RT-VBR1
•
RT-VBR2
•
• RT-VBR3
• NRT-VBR1
• NRT-VBR2
• NRT-VBR3
• UBR1
UBR2
•
ABRSD
•
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
dspchans
4-129