Table 2-3 Line Parameters For The Cnfln Command - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

Chapter 2 Provisioning Communications Links
Step 3 To display the configuration information for the particular line that you want to configure, enter a dspln
command in the format shown below:
PXM1E_SJ.1.5.AUSMB8.a > dspln 1
LineNum:
LineConnectorType:
LineType:
LineEnable:
LineCoding:
LineLength:
LineXmtClockSource:
LineLoopbackCommand:
LineSendCode:
LineUsedTimeslotsBitMap:
LineLoopbackCodeDetection: codeDetectDisabled
LineBERTEnable:
LineNumOfValidEntries: 8
PXM1E_SJ.1.5.AUSMB8.a >
This sample dspln command shows the configuration parameters of a T1 line for an AUSM card that is
installed in slot 1.
To configure a line on an AUSM card, enter a cnfln command in the format shown below:
Step 4
PXM1E_SJ.1.5.AUSMB8.a > cnfln <line_num> <line_code> <line_len> <clk_src> [E1-signalling]
Table 2-3
card.
Table 2-3
Parameter
line_num
line_code
line_len
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
1
lists and describes the parameters that you use in configuring T1 and E1 lines on an AUSM
Line Parameters for the cnfln Command
Description
Enter the number of the line you want to configure. Use the dsplns command to
display the available lines.
Select the line coding:
B8ZS (T1) = 2
•
• HDB3 (E1) = 3
Enter the length of the line:
• T1 range:
– 0 to 131 feet = 10
131 to 262 feet = 11
–
262 to 393 feet = 12
–
– 393 to 524 feet = 13
– 524 to 655 feet = 14
>655 feet = 15
–
• E1 (with SMB line module) = 8
• E1 (with RJ48 line module) = 9
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
RJ-48
dsx1ESF
Enabled
dsx1B8ZS
0-131 ft
LocalTiming
NoLoop
NoCode
0xffffff
Disable
General AUSM Provisioning Procedures
2-9