Table 1-1 Ausm Card Types Supported By Pxm1E Controllers - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

Introduction
This chapter introduces the AUSM cards that are supported by the PXM1E card in MGX 8850 and
MGX 8830 switches. This chapter also describes the features of these cards.
AUSM Card Types
When operating under control of the PXM1E card, the MGX 8850 and MGX 8830 switches support the
AUSM cards listed in
Table 1-1
Front Card
AUSM-8T1/B
AUSM-8E1/B
The preferred tools to configure, monitor, and control service modules are the CiscoView and Cisco
WAN Manager applications for equipment management and connection management. (The Cisco WAN
Manager application is the former Cisco StrataView Plus application with the equipment management
removed.) However, the command-line interface (CLI) also provides access the service modules and is
highly applicable during initial installation, troubleshooting, and any situation where low-level control
is useful.
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Table 1-1.
AUSM Card Types Supported by PXM1E Controllers
Back Card
RJ48-8T1,
RJ48-8T1-R
RJ48-8E1,
SMB-8E1,
RJ48-8E1-R,
SMB-8E1-R
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
C H A P T E R
Maximum
Connections
1000
1000
1
1-1