Tstconseg - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

tstconseg

tstconseg
Test Connection Segment
Use the tstconseg command to test the integrity of a connection you have created with the addcon
command. The tstconseg command tests the connection between the switch and an attached CPE device.
Syntax
tstconseg <port_num.vpi.vci | channel_num>
Syntax Description
port_num
vpi
vci
channel_num
Related Commands
addcon, cnfcon, delcon, dncon, dspcon, dspcons, rrtcon, tstcon, tstdelay, upcon
Attributes
Log: No
Example
Test the connection labeled channel 16.
PXM1E_SJ.1.13.AUSMB8.a > tstconseg 16
PXM1E_SJ.1.13.AUSMB8.a >
Segment Loopback Test (CPE side) Failed.
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
4-188
Enter the port number for the connection you want to test. To display a list of
configured ports, enter the dspports command. To display a complete list of
connections, enter the dspcons command.
Enter the VPI of the connection you want to display. The VPI for a connection
is displayed in the dspcons command report.
Enter the VCI of the connection you want to display. The VCI for a connection
is displayed in the dspcons command report.
Enter the channel number of the connection you want to test. The dspcons
command displays connection channel numbers in the LCN column.
State: Active Privilege: Group 4
Chapter 4 AUSM Command Reference
Release 3, Part Number 78-14254-01 Rev. A0, October 2002