Table of Contents
Advertisement
Chapter 4
AUSM Command Reference
addrscprtn
Add Resource Partition
A resource partition assigns port resources such as bandwidth and a VPI and VCI range to a specific
controller such as PNNI. In this release, a PNNI resource partition is automatically created when a port
is created, and all resources are assigned to the PNNI controller. Use the addrscprtn command to add a
resource partition after you have deleted the resource partition for a port.
Syntax
addrscprtn <port_num> <cntrlr_type> <pct_bw_ingr> <pct_bw_egr> <low_vpi> <high_vpi>
<low_vci> <high_vci> <low_vpid> <high_vpid> <max_lcn> <cntrlr_id>
Syntax Description
port_num
cntrlr_type
pct_bw_ingr
pct_bw_egr
low_vpi
high_vpi
low_vci
high_vci
low_vpid
high_vpid
max_lcn
cntrlr_id
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Port number to be partitioned. You must add a port to a line before you can
define a partition for a port. Use the dspports command to view the available
ports.
Controller for this partition. Enter 2 as the PNNI controller is the only controller
type supported in this release.
PAR = 1
•
•
PNNI = 2
MPLS = 3
•
Ingress bandwidth percentage. Enter the percentage of the line bandwidth to be
used by this controller for ingress communications. Range is 1 to 100 percent.
Egress bandwidth percentage. Enter the percentage of the line bandwidth to be
used by this controller for egress communications. Range is 1 to 100 percent.
Enter the minimum VPI number to allow for connections using the specified
controller type (cntrlr_type) on this port. The range is from 0 to 255.
Enter the maximum VPI number to allow for connections using the specified
controller type (cntrlr_type) on this port. The range is from 0 to 255.
Enter the minimum VCI number to allow for connections using the specified
controller type (cntrlr_type) on this port. The range is from 0 to 65535.
Enter the maximum VCI number to allow for connections using the specified
controller type (cntrlr_type) on this port. The range is from 0 to 65535.
Enter the minimum virtual path identification number to allow for connections
using the specified controller type (cntrlr_type) on this port. The range is from
1 to 1000.
Enter the maximum virtual path identification number to allow for connections
using the specified controller type (cntrlr_type) on this port. The range is from
1 to 1000.
Maximum LCN to be used on this port. Range is 1 to 1000.
Enter a number that will be associated with the controller used by this partition.
Range is 1 to 255.
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
addrscprtn
4-21
Advertisement
Table of Contents
