Setpagemode - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

setpagemode

setpagemode
Set Page Mode
Use the setpagemode command to enable or disable the paging feature. When the paging feature is
enabled, commands display information in pages that do not exceed the length of the display. If a
command report requires more than one page, press Return to display the next page, or press Q to
abandon the report. Non-paged reports display without interruption, but you may need to scroll up to see
the information at the top of the report.
Syntax
setpagemode <on|off>
Syntax Description
<on|off>
Related Commands
None
Attributes
Log: No
Example
Enable command report paging.
PXM1E_SJ.1.21.AUSMB8.a > setpagemode on
PXM1E_SJ.1.21.AUSMB8.a >
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
4-186
Specify on to enable paging, or specify off to disable this feature.
State: Any Privilege: Any User
Chapter 4 AUSM Command Reference
Release 3, Part Number 78-14254-01 Rev. A0, October 2002