Cnfln - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

cnfln

cnfln
Configure Line
Use the optional cnfln command to configure line characteristics after the line becomes active (see
addln).
Syntax
cnfln
Syntax Description
line_num
line_code
line_len
clk_src
E1-signalling
Related Commands
addln, delln, dspln, dsplns
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
4-70
<line_num> <line_code> <line_len> <clk_src> [E1-signalling]
Enter the number of the line you want to configure. Use the dsplns command to
display the available lines.
Select the line coding:
• B8ZS (T1) = 2
• HDB3 (E1) = 3
Enter the length of the line:
T1 range:
•
0 to 131 feet = 10
–
131 to 262 feet = 11
–
262 to 393 feet = 12
–
– 393 to 524 feet = 13
– 524 to 655 feet = 14
– >655 feet = 15
E1 (with SMB line module) = 8
•
• E1 (with RJ48 line module) = 9
DSX1 clock source.
• 1 = loop clock
• 2 = local clock
This option selects E1 signalling methods. Enter the keyword for the signalling
combination listed below:
• CCS, no CRC = CCS
• CCS, with CRC = CCS_CRC
Clear E1 = CLEAR
•
Chapter 4 AUSM Command Reference
Release 3, Part Number 78-14254-01 Rev. A0, October 2002