Cnfslftst - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

cnfslftst

cnfslftst
Configure Self-Test
Use the cnfslftst command to enable or disable self testing and to configure how often the tests are run
on the current AUSM card.
Syntax
cnfslftst -en <SelftestEnable> -tm <SelftestPeriod>
Syntax Description
-en
-tm
Related Commands
clrslftst, dspslftst, dspslftsttbl, runslftstno
Attributes
Log: Yes
Example
The following example enables self testing and configures the testing to repeat every minute.
PXM1E_SJ.1.21.AUSMB8.a > cnfslftst -en 2 -tm 1
PXM1E_SJ.1.21.AUSMB8.a >
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
4-80
This option enables or disables self testing. Replace SelftestEnable with one of
the following values:
Disable = 1
•
• Enable = 2
This option defines the period, in minutes, between self-tests. The range is 1 to
60.
State: Active Privilege: Any User
Chapter 4 AUSM Command Reference
Release 3, Part Number 78-14254-01 Rev. A0, October 2002