Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference page 158

cnfupccbr
EgSrvRate
EgPcUtil
Related Commands
dspcon, dspcons
Attributes
Log: Yes
Example
Set connection bandwidth control parameters for the constant bit rate (CBR) connection type on the
current AUSM.
s1.1.12.AUSMB8.a > cnfupccbr 2.1.1 2 4528 250000 50 4528 50
Set connection bandwidth control parameters for the constant bit rate (CBR) connection type on the
current AUSM (using channel number argument).
s1.1.12.AUSMB8.a > cnfupccbr 21 2 4528 250000 50 4528 50
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
4-84
Egress service rate. The range depends on the speed of the logical port:
• T1 = 10 to 3622
E1 = 10 to 4528
•
• Clear E1 = 10 to 4830
• IMA T1 = 10 to (3591 * number_of_lines)
IMA E1 = 10 to (4490 * number_of_lines)
•
IMA clear E1 = 10 to (4789 * number_of_lines)
•
An IMA group's range depends on the number of links in the group.
Note
Multiply the single line rate by the number of lines.
Egress percentage utilization.
Range: 1–127
State: Active Privilege: Group 2
Chapter 4 AUSM Command Reference
Release 3, Part Number 78-14254-01 Rev. A0, October 2002