Table of Contents
Advertisement
Provisioning Communications Links
This chapter describes how to bring up ATM communications on the physical ports of the AUSM cards
using the command-line interface (CLI).
AUSM cards, lines, and ports can also be configured using the CiscoView application. Refer to the
Note
CiscoView documentation for the directions.
The easiest way to add connections is by using the Cisco WAN Manager application. For full details
Note
on how to set up a connection through the Cisco WAN Manager GUI, refer to the Cisco WAN
Manager User's Guide.
This chapter explains how to provision the link and connection types described in
Table 2-1
AUSM Link and Connection
Type
Lines
Ports
AUSM-to-AUSM SPVCs
AUSM-to-Non-AUSM SPVCs An AUSM-to-non-AUSM SPVC establishes a connection between an
To eliminate redundancy and help experienced users complete configuration tasks quickly and
efficiently, this chapter provides configuration quickstart procedures.
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Link and Connection Types Applicable to AUSM Cards
Description
Lines establish physical layer connectivity between a AUSM port and
the same port type (T1, for example) on another device.
Ports establish ATM communications over a line to ATM customer
premises equipment (CPE).
Soft permanent virtual circuits (SPVCs) are permanent connections
that can be rerouted in the event of a link failure. An AUSM-to-AUSM
SPVC establishes a connection between two AUSM ports. Such ports
can be on the same card, on different cards in the same switch, or on
different cards in different switches.
AUSM port and a port on a non-AUSM card such as a FRSM, RPM,
or AXSM card. Such ports can be on different cards in the same switch
or on different cards in different switches.
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
C H A P T E R
Table
2
2-1.
2-1
Advertisement
Table of Contents
