Chapter 4
AUSM Command Reference
cnfimaalmparm
Configure IMA Alarm Parameters
Use the cnfimaalmparm command to configure the IMA alarm parameters for a specified IMA group.
There are two IMA alarm parameters. One parameter defines how long an IMA group must be down
before an alarm is generated. The other parameter defines how long a previously downed IMA group
must be up before another alarm reports that the group is back up.
Syntax
cnfimaalmparm <group_num> <up_time> <down_time>
Syntax Description
group_num
up_time
down_time
Related Commands
dspimaalmparm
Attributes
Log: No
Example
Configure the IMA alarm parameters for group 1 to the default values.
PXM1E_SJ.1.1.AUSMB8.a > cnfimaalmparm 1 2500 10000
PXM1E_SJ.1.1.AUSMB8.a >
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Enter the number for the IMA group you want to configure. Use the
dspimagrps command to display the configured IMA groups.
Enter the number of milliseconds a previously downed IMA group must be up
before a recovery alarm is generated. The range is 100 to 100,000 ms.
Enter the number of milliseconds that an IMA group must be down before an
alarm is generated. The range 100 to 400,000 ms.
State: Any
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
Privilege: Group 1
cnfimaalmparm
4-67