Table of Contents
Advertisement
addspvc
-st
-master
-rmc
-abrtype
-abrpcr
-abrmcr
-osub
-ipcu
-epcu
-upce
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
4-24
Service class type. Select one of the following service types:
•
CBR = 1 (default)
CBR1 = 21
•
•
CBR2 = 31
•
CBR3 = 32
rtVBR = 5
•
rtVBR1 = 22
•
rtVBR2 = 23
•
rtVBR3 = 24
•
nrtVBR = 2
•
•
nrtVBR1 = 25
•
nrtVBR2 = 26
•
nrtVBR3 = 27
ABR = 3
•
•
UBR = 4
UBR1 = 28
•
UBR2 = 29
•
Mastership role of connection. Select from the following options:
1 = master
•
•
2 = slave (default)
Remote connection ID. This option is used when defining the master end of a
connection. Enter the slave connection ID as it appears after the addcon
command is issued. The format is: RemoteNsapAddress.VPI.VCI.
ABR connection behavior type:
•
Switch behavior = 1
Source/destination behavior = 2
•
Peak cell rate for ABR connections. The range is 10 to 38328 cps.
Minimum cell rate for ABR connections. The range is 10 to 38328 cps.
Subscription override. To apply CAC, enter -osub 1. To ignore CAC, enter
-osub 2. Default setting does not apply CAC.
Ingress percent utilization. Range is 1 to 100 percent. Default setting is 100
percent.
Egress percent utilization. Range is 1 to 100 percent. Default setting is 100
percent.
Usage parameter control (UPC) feature. Enter 1 to disable this feature, or enter
2 to enable UPC.
Note
This option only applies to the following service class types (-st option):
CBR (1), nrtVBR (2), ABR (3), UBR (4), and rtVBR (5).
Chapter 4
AUSM Command Reference
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Advertisement
Table of Contents
