Table of Contents
Advertisement
cnfautorestart
cnfautorestart
Configure Auto Restart
The cnfautorestart command enables or disables the IMA group automatic restart feature for all IMA
groups on the current AUSM card. This feature automatically restarts an IMA group when IMA group
operation stops due to the following types of service events:
•
•
•
Line changes can halt IMA group operation when the affected lines are the only operational lines in the
IMA group.
Note
For the IMA automatic restart feature to work properly, the IMA group IDs (addimagrp command) at
each end of the IMA connection must be different. If the IMA group IDs are the same, the AUSM card
can not differentiate between lines that are connected to the remote switch and lines that are in loopback
mode.
Syntax
cnfautorestart <type>
Syntax Description
type
Related Commands
dspautorestart, restartimagrp
Attributes
Log: Yes
Example
Enable the IMA group automatic restart feature.
PXM1E_SJ.1.1.AUSMB8.a > cnfautorestart 2
PXM1E_SJ.1.1.AUSMB8.a >
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
4-52
One or more lines placed in loopback at the near or far end
One or more lines inadvertently moved to another switch
The far end IMA group is deleted and re-added
Enter 1 to disable the automatic restart feature, or enter 2 to enable this feature.
State: Active
Privilege: Group 1
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Chapter 4
AUSM Command Reference
Advertisement
Table of Contents
