addcon
-upce
-scrp
-ccdv
-cte
-dis
-pcr01
-scr
-cbs
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
4-12
Usage parameter control (UPC) feature. Enter 1 to disable this feature, or enter
2 to enable UPC.
Note
This option only applies to the following service class types (-st option):
CBR (1), nrtVBR (2), ABR (3), UBR (4), and rtVBR (5).
Sustainable Cell Rate (SCR) policing method:
•
CLP[0] = 1
•
CLP[0+1] = 2
•
No SCR policing = 3
Note
This option only applies to the following service class types (-st option):
CBR (1), nrtVBR (2), ABR (3), UBR (4), and rtVBR (5).
Enter the Cell Delay Variation Tolerance (CDVT[0+1]). The range is 1 to
250000 microseconds.
Cell Loss Priority (CLP) tagging feature. Enter 1 to disable this feature, or
•
enter 2 to enable CLP tagging.
Note
This option only applies to the following service class types (-st option):
CBR (1), nrtVBR (2), ABR (3), UBR (4), and rtVBR (5).
Enter the cell discard method:
CLP hysteresis = 1
•
•
Frame based = 2
Peak cell rate for cells with CLP = 0 and CLP = 1. The range depends on the
speed of the logical port:
•
T1 = 10 to 3622
•
E1 = 10 to 4528
•
Clear E1 = 10 to 4830
•
IMA T1 = 10 to (3591 * number_of_lines)
•
IMA E1 = 10 to (4490 * number_of_lines)
IMA clear E1 = 10 to (4789 * number_of_lines)
•
An IMA group's range depends on the number of links in the group.
Note
Multiply the single line rate by the number of lines.
Select the ingress UPC Committed Information Rate (CIR). The range depends
on the speed of the logical port:
T1 = 10 to 3622
•
E1 = 10 to 4528
•
•
Clear E1 = 10 to 4830
•
IMA T1 = 10 to (3591 * number_of_lines)
•
IMA E1 = 10 to (4490 * number_of_lines)
IMA clear E1 = 10 to (4789 * number_of_lines)
•
Note
An IMA group's range depends on the number of links in the group.
Multiply the single line rate by the number of lines.
Enter the maximum burst size. The range is 1 to 5000 cells.
Chapter 4
AUSM Command Reference
Release 3, Part Number 78-14254-01 Rev. A0, October 2002