Dspimaln - Cisco MGX 8850 PXM1E Software Configuration Manual And Command Reference

Chapter 4 AUSM Command Reference

dspimaln

Display IMA Line Status
Use the dspimaln command to view the status for the specified line in an IMA group.
Syntax
dspimalncnt <group_num> <linenum>
Syntax Description
group_num
linenum
Related Commands
clrimagrpcnt, clrimalncnt, dspimagrp, dspimagrpcnt, dspimagrps, dspimainfo, dspimalncnt
Attributes
Log: No
Example
Display the line status for line 2 of IMA group 1.
PXM1E_SJ.1.1.AUSMB8.a > dspimaln 1 2
IMA Group number
Link number
ImaLink TxLId
ImaLink RxLId
LinkNeRxState
LinkNeTxState
LinkNeRxFailureStatus
LinkFeRxState
LinkFeTxState
LinkFeRxFailureStatus
LinkRelDelay
LinkRxTestPattern
Ne Link Tx Num Failures
Ne Link Rx Num Failures
PXM1E_SJ.1.1.AUSMB8.a >
Release 3, Part Number 78-14254-01 Rev. A0, October 2002
Enter the number for the IMA group you want to display. Use the dspimagrps
command to display the configured IMA groups.
Enter the number for the line you want to display. Use the dspimagrps
command to display the lines assigned to an IMA group.
State: Any
Cisco AUSM Software Configuration Guide and Command Reference for MGX 8850 (PXM1E) and MGX 8830
Privilege: Group 1
: 1
: 2
: 0x1
: 0x1
: Active
: Active
: No Failure
: Active
: Active
: No Failure
: 0
: 1
: 0
: 0
dspimaln
4-147