Chapter 3 Configuring The Atm Module; Accessing The Command-Line Interface - Cisco Catalyst 2900 XL Series Installation And Configuration Manual

Configuring the ATM Module
This chapter provides procedures for configuring the ATM module. The procedures include
configuring the ATM LAN emulation (LANE) client (LEC) from the command-line
interface (CLI) and verifying the configuration. Additionally, this chapter explains how to
manually configure the ATM module to support RFC 1483. For information about the
trunking and nontrunking features, see the Catalyst 2900 Series XL Enterprise Edition
Software Configuration Guide. For detailed information about commands used in this
chapter, see the "Command Reference" appendix.

Accessing the Command-Line Interface

You can enter Cisco IOS commands to configure the LEC software on the ATM module.
To start an ATM session, enter the session session-number command at the switch prompt
in priviledged EXEC mode.
switch# session 1
ATM>Entering Console for module in slot 1
Type
Press RETURN to get started!
ATM>
If the ATM module is installed in Slot A, the session displays interface 1; if the module is
installed in Slot B, the session displays interface 2.
"^G" to end this session
C H A P T E R
Configuring the ATM Module 3-1
3