Recommended Products; Precautions - Omron CS1W-FLN22 Operation Manual

Network Installation
3-6-2

Recommended Products

3-6-3

Precautions

Precautions on Laying Twisted-pair Cable
Basic Precautions
Environment Precautions
The following products are recommended for use with the CS1W-ETN21
Ethernet Unit.
Part Maker
Hub 10Base-T
Allied RH509E
Telesis
MR820TLX
Twisted-pair 100Base-TX
cable
Fujikura F-LINK-E
0.5mm x 4P
Fujikura CTP-LAN5
0.5mm x 4P
10Base-T
Fujikura F-LINK-E
0.5mm x 4P
Fujikura CTP-LAN5
0.5mm x 4P
Connectors STP Plug
(Modular
Panduit MPS588
plug)
Corp
UTP Plug
Panduit MP588-C
Corp
• Press the cable connector in firmly until it locks into place at both the hub
and the Ethernet Unit.
• After laying the twisted-pair cable, check the connection with a 10Base-T
cable tester.
• The UTP cable is not shielded, and the hub is designed for use in OA
environments. In environments subject to noise, construct a system with
shielded twisted-pair (STP) cable and hubs suitable for an FA environ-
ment.
• Do not lay the twisted-pair cable together with high-voltage lines.
• Do not lay the twisted-pair cable near devices that generate noise.
• Do not lay the twisted-pair cable in locations subject to high temperatures
or high humidity.
• Do not lay the twisted-pair cable in locations subject to excessive dirt and
dust or to oil mist or other contaminants.
Model Specifications
number
9-port hub
9-port hub with 10Base-5
backbone port
STP (shielded twisted-
pair) cable: Category 5,
5e
Note: Impedance is lim-
ited to 100 Ω.
UTP (unshielded twisted-
pair) cable: Category 5,
5e
STP (shielded twisted-
pair) cable: Category 3,
4, 5, 5e
Note: Impedance is lim-
ited to 100 Ω.
UTP (unshielded twisted-
pair) cable: Category 3,
4, 5, 5e
---
---
Section 3-6
Inquires
Allied Telesis
(0120) 86-0442
(in Japan only)
---
35