Omron CS1W-FLN22 Operation Manual page 261

FL-net Unit Support Software Ver. 1.6
System Setting (Other Node Setup Area)
The Other Node Setup Area are be set so that Common Memory data for remote nodes can be read to the
local PLC areas.
(1)
(3)
(7)
(1) Area 1 (Area 2) Memory Area (Default: DM)
Sets the PLC area in which Cyclic Data Areas 1 and 2 for the remote nodes are stored.
The following areas can be set: CIO, WR, HR, DM, and EM0 to EMC.
(2) Area 1 (Area 2) start word (Default: 0)
Sets the beginning word of the PLC area in which Cyclic Data Areas 1 and 2 for the remote nodes are
stored.
(3) Mapping area table
Sets the offset, size and mapped node numbers of the PLC area in which Cyclic Data Areas 1 and 2 for the
remote nodes are stored. (See note 1.)
(4) Clear all
Clears all entries in the mapped area table.
(5) Copy row
Copies the contents of the row in which the cursor is placed, and adds it as a new row.
(6) Delete
Deletes the contents of the row in which the cursor is placed. Any settings after the deleted row are moved
forward in the table.
(7) Show data
Selects whether data is to be displayed in decimal or hexadecimal.
(8) Send
Writes set data to the System Setup Area of the specified Unit.
(9) Receive
Reads the contents of the System Setup Area of the specified Unit to the FL-net Unit Support Software.
(8) (9) (10) (11)
(2)
(4)
(5)
(6)
Appendix F
235