Omron CS1W-FLN22 Operation Manual page 260

FL-net Unit Support Software Ver. 1.6
System Setting (Local Node Setup Area)
The Local Node Setup Area can be set so that data from any PLC area can be used as the send data from the
local node
(2)
(1)
(5)
(1) Area 1 (Area 2) Memory Area (Default: DM)
Sets the PLC area in which Cyclic Data Areas 1 and 2 for the local node are stored.
The following areas can be set: CIO, WR, HR, DM, and EM0 to EMC.
(2) Area 1 (Area 2) start word (Default: 0)
Sets the beginning word of the PLC area in which Cyclic Data Areas 1 and 2 for the local node are stored.
(3) Area 1 (Area 2) size (Default: 0)
Sets the size of the PLC area in which Cyclic Data Areas 1 and 2 for the local node are stored. This setting
also determines the size allocated to this node in Common Memory.
(4) Area 1 (Area 2) Start address of Common Memory (Default: 0)
Sets the beginning address of the Common Memory allocated to Area 1 (or Area 2).
(5) Show data
Selects whether data is to be given in decimal or hexadecimal.
(6) Send
Writes set data to the System Setup Area of the specified Unit.
(7) Receive
Reads the contents of the System Setup Area of the specified Unit to the FL-net Unit Support Software.
(8) OK
Validates the changed settings and closes the window.
When the System Setup Window is next opened, the changed settings will be displayed.
(9) Cancel
Cancels the changes to the settings and closes the window.
When the System Setup Window is next opened, the settings prior to the changes will be displayed.
234
(6) (7) (8)
(3)
(4)
(9)
Appendix F