Network Settings - Omron CS1W-FLN22 Operation Manual

Operating Procedures

11-2-3 Network Settings

172
Menu Command
View Toolbar
Status bar
Setting To PLC
From PLC
Compare with
PLC
Network setting
Status Datalink Status
Error Status
Communication
cycle time
Message
sequential status
Error log
Node status
Network status
Option Extension setting Changes the order of link data bytes.
Switch display
Help Index
Version
This section explains how to connect the PLC to a computer on which the FL-
net Unit Support Software is installed. These settings are not required if the
CX-FLnet is launched from the I/O Table Component of the CX-Programmer.
Change the communications settings in the following cases.
• When the CX-FLnet is launched from the I/O Table Component without
inheriting network settings.
• When the CX-FLnet is started from the Windows Start Menu.
• When the FL-net target node is changed (i.e., when the network address,
node address, or unit number is changed).
Contents
Switches the toolbar display.
Switches the status bar display.
Writes to the setup data of the specified Unit.
Reads the contents of the setup data of the specified
Unit to the computer.
Compares system settings on the computer with the
PLC.
Makes network settings to communicate with the PLC.
Shows the FL-net network data link status.
Shows the FL-net Unit error status.
Shows the communications cycle time of the FL-net net-
work.
Shows the message sequence status.
Shows the FL-net Unit error log.
Shows the node status in the FL-net network.
Shows the FL-net network status.
Switches the display between decimal and hexadecimal.
Shows the help files.
Shows the CX-FLnet version.
Section 11-2