Omron CS1W-FLN22 Operation Manual page 95

Setting Data Link Tables
System Setting (Local
Node Setup Area)
Item
Area 1 (Area 2) Memory Area
(default: Area 1 CIO, Area 2 DM)
Area 1 (Area 2) start word
(default: 0)
Area 1 (Area 2) size
(default: 0)
Area 1 (Area 2) Start address of
Common Memory
(default: 0)
The Local Node Setup Area can be set so that data from any PLC area can
be used as the send data from the local node.
Sets the PLC area in which Cyclic Data Areas 1 and 2 for the local node are stored.
The following areas can be set: CIO, WR, HR, DM, and EM0 to EMC.
Sets the beginning word of the PLC area in which Cyclic Data Areas 1 and 2 for the
local node are stored.
Sets the size of the PLC area in which Cyclic Data Areas 1 and 2 for the local node
are stored. This setting also determines the size allocated to this node for Common
Memory.
Sets the beginning address of the Common Memory allocated to Area 1 (or Area 2).
Note Select Option - Switch display - Hex. It will be possible to display and input
words, sizes, and addresses in hexadecimal.
Content
Section 5-2
69