Hardware Setup
Note
32
Be sure to read and understand all of the following information for each setting
method before setting the IP addresses. For details on FL-net IP addresses,
refer to FL-net IP Address under Appendix C Network System Definitions.
IP address setting
method
192.168.250 + node
number
Setup area
1. After changing IP addresses or other settings with any of these setting
methods, restart the FL-net Unit.
2. If the IP address of an earlier FL-net Unit (CS1W-FLN02 and CS1W-
FLN12) was set using the rotary switch on the rear of the Unit, reset the IP
address using the CX-FLnet or FL-net Unit Support Software with either of
the above two methods.
Note If a subnet mask is to be set, use the Support Software to set it in the CPU
Bus Unit Setup Area. For details, refer to SECTION 11 CX-FLnet Support
Software Operations.
Node number setting
method
Rotary switches on front of
Unit (Node Number Switches)
Fourth octet of IP address
(rightmost eight bits of the IP
address)
Section 3-4
Details
This is the default FL-net net-
work address. The node num-
ber is set using the rotary
switches on the front of the
Unit.
The IP address can be set
when writing the Setup data
using the CX-FLnet or FL-net
Unit Support Software. The
CX-FLnet or FL-net Unit Sup-
port Software is required to
change the IP addresses.