System Configuration; Device Configuration - Omron CS1W-FLN22 Operation Manual

System Configuration

1-2 System Configuration
1-2-1

Device Configuration

10Base-T
Terminator
Between nodes:
Integral multiples of 2.5 m
Transceiver
50 m max.
Transceiver cable
CS/CJ-series
CS1W-FLN22 or
CJ1W-FLN22
FL-net Unit
100Base-TX
Twisted-pair
cable
100 m max.
CS-series PLC
CS-series
CS1W-FLN22
FL-net Unit
(100Base-TX)
Other company's
FL-net (Ver. 2.0) node
10Base-T
CS-series
PLC
Hub
Hub
100 m max.
CS-series
CJ1W-FLN22
FL-net Unit
(100Base-TX)
CS-series DeviceNet Unit
Note Do not combine nodes using a baud rate of 10 Mbps with nodes using a baud
rate of 100 Mbps in the same configuration, where possible. If nodes with a
baud rate of 10 Mbps are used, use a baud rate of 10 Mbps for all the con-
nected devices in the configuration.
FL-net (Ver. 2.00) (10 Mbps)
500 m/segment max.
10Base-5 coaxial cable
(or 10Base-T twisted-pair cable)
Hub
CS-series
100 m max.
CS1W-FLN12
FL-net (Ver. 2.00) Unit
(10Base-T)
CS-series
DeviceNet Unit
Remote Terminal
Hub
100 m max.
CS-series
CS1W-FLN22
FL-net Unit
(100Base-TX)
Remote Terminal
Section 1-2
Terminator
Ground
Other company's
FL-net (Ver. 2.0) node
10Base-T
DeviceNet
Sensor Actuator
CX-Programmer
Other company's
FL-net node
100Base-TX
DeviceNet
Sensor Actuator
7