System Setting - Cpu Bus Unit Setup Area - Omron CS1W-FLN22 Operation Manual

Operating Procedures

11-2-4 System Setting - CPU Bus Unit Setup Area

Item
FA Link mapping table method
(default: PLC build-in method)
FA Link startup method
(default: Auto-participating
method)
Confirm message protocol
(default: Confirmed)
Broadcast type
(default: ***.***.***.255)
IP address set method
(default: 192.168.250 + Node No.)
Sub-net mask
(default: 255.255.255.0)
10. Input the unit number (0 to 15) of FL-net Unit to be connected in the Com-
munication Setting Dialog Box.
11. Click the Close Button to finish setting.
Any of several operating parameters can be selected depending on the sys-
tem, but the explanation is provided here for simple operating conditions.
Selects the method (PLC build-in method or FA Link Unit build-in method) for storing
the FA Link mapping table.
Normally the default should be selected.
Selects the method (auto-participating or manual-participating) for starting the FA
Link.
Normally the default should be selected.
Selects the protocol (confirmed or unconfirmed) for when messages are used.
Select Confirmed for a network with OMRON FL-net Units only.
Select Unconfirmed for a network in which units from other manufacturers are con-
nected.
Selects the broadcast type (***.***.***.255 or C255.255.255.255).
Normally the default should be selected.
Selects the IP address setting method (192.168.250 + Node No., Unit rear rotary SW,
Unit rear rotary SW + Node No., or Setup Area).
Normally the default should be selected.
When using the CS1W-FLN22 or CJ1W-FLN22, select either 192.168.250 + Node No
or Setup Area.
Sets the sub-net mask (user setting).
Normally the default should be selected.
Content
Section 11-2
177