FL-net Unit Support Software Ver. 1.6
7. The installation will be started, and the Installer will begin preparations. When the next disk is required, a
message will be displayed requesting that Setup Disk 2 be inserted into the drive.
8. The following window will be displayed. Click the OK Button.
9. Specify the directory where the Support Software software is to be installed.
If the directory displayed is correct, then click the Icon Button.
To install the software in another directory, click the Change Directory Button and specify the storage loca-
tion. Then click the Icon Button. If a directory that does not exist is specified, it will be automatically created.
10. The software will be installed. When the installation is finished, the following window will be displayed. Click
the OK Button to complete the setup.
11. This completes the software installation.
Appendix F
225