System Setting - Other Node Setup Area - Omron CS1W-FLN22 Operation Manual

Operating Procedures
Item
Area 1 (Area 2) Memory Area
(default: Area 1 CIO, Area 2 DM)
Area 1 (Area 2) start word
(default: 0)
Area 1 (Area 2) size
(default: 0)
Area 1 (Area 2) Start address of
Common Memory
(default: 0)

11-2-6 System Setting - Other Node Setup Area

Item
Area 1 (Area 2) Memory Area
(default: Area 1 CIO, Area 2 DM)
Area 1 (Area 2) start word
(default: 0)
Mapping area table
Sets the PLC area in which Cyclic Data Areas 1 and 2 for the local node are stored.
The following areas can be set: CIO, WR, HR, DM, and EM0 to EMC.
Sets the beginning word of the PLC area in which Cyclic Data Areas 1 and 2 for the
local node are stored.
Sets the size of the PLC area in which Cyclic Data Areas 1 and 2 for the local node
are stored. This setting also determines the size allocated to this node for Common
Memory.
Sets the beginning address of the Common Memory allocated to Area 1 (or Area 2).
Note Select Option - Switch display - Hex. It will be possible to display and input
words, sizes, and addresses in hexadecimal.
The other node setup areas are be set so that Common Memory data for
remote nodes can be read to the local PLC areas.
The following functions can be used when setting the other node setup areas.
Sets the PLC area in which Cyclic Data Areas 1 and 2 for the remote nodes are
stored.
The following areas can be set: CIO, WR, HR, DM, and EM0 to EMC.
Sets the beginning word of the PLC area in which Cyclic Data Areas 1 and 2 for the
remote nodes are stored.
Sets the offset, size and mapped node numbers of the PLC area in which Cyclic Data
Areas 1 and 2 for the remote nodes are stored.
Menu
Edit - Clear all
Content
Content
Function
Clear all data in the FA link table.
Section 11-2
179