Connecting Programming Devices; Transferring Programs; Recommended Programming Device Operations - Omron SYSMAC CVM1 Series Operation Manual

Programming Devices

1-7-2 Connecting Programming Devices

1-7-3 Transferring Programs

1-7-4 Recommended Programming Device Operations

Checking the PC Setup
8
Programming Devices can be connected to the Duplex Unit's peripheral con-
nector, the Duplex Unit's host link connector, or a CV500-II201 I/O Interface
Unit's peripheral connector.
CV500-II201
Programming
Console
The baud rate for transmissions with a personal computer running SSS depends
upon the location where the computer is connected.
Connection location
Duplex Unit p Peripheral connector p
Host link connector
I/O Interface Unit Peripheral connector
(CV500-II201) (CV500 II201)
Host link connector
Set the baud rate on the Duplex Unit's DIP Switch. When the host link connector
is being used, the baud rate can be changed in the PC Setup (19.2, 9.6, 4.8, or
2.4 Kbps). To enable the baud rate setting in the PC Setup, turn OFF pins 3 and 4
of the Duplex Unit's DIP Switch.
A program can be written or edited offline with the SSS and then transferred to
PC online. Refer to the SSS Operation Manual for details on writing, editing, and
transferring programs.
The CVM1D's PC Setup settings can be changed with the SSS. The PC Setup
settings are all set to their default values when the CPU Unit is shipped. Verify
that the PC Setup settings are appropriate for the planned PC applications.
Refer to Section 7 PC Setup for details on the PC Setup. Refer to the SSS Op-
eration Manual for details on changing the PC Setup settings.
CPU Rack
Connects to host link connector
Connects to peripheral connector
Expansion I/O Rack
Expansion I/O Rack
Programming Device
Programming Console
SSS
SSS
Programming Console
SSS
Section 1-7
Programming
Console
Baud rate
50 Kbps
19.2, 9.6, or
4.8 Kbps
9.6 Kbps
50 Kbps
19.2, 9.6, or
4.8 Kbps