Omron CS1W-FLN22 Operation Manual page 212

Operating Procedures
Network Status
Transferring and
Comparing System
Settings
186
ERR_CODE
0
1
Note For information on FL-net node error codes in Units from other companies,
refer to the relevant manuals.
■ Allowed Refresh Cycle Time, Token Watchdog Timer, Allowed Minimum
Frame Interval
The allowed refresh cycle time, the token watchdog timer, and the allowed
minimum frame interval are displayed for the node set by the node number.
The status of remote nodes participating in the FL-net network is shown. The
status shown here is the same as the network status which is stored in the
DM Area.
■
Mapping Error
Indicates that the settings do not correctly reflect the network data in the PLC
areas. Recheck the settings.
■ Participation in Network
Network participation status is stored.
The operating status and error status data is not valid if the node is not partic-
ipating in the network. (The upper layer status when changing from participat-
ing to not participating is retained.)
■ Error (Upper Layer)
The error status (error/no error) of applications installed at the node is stored.
■
Run (Upper Layer)
The operating status (active/not active) of applications installed at the node is
stored.
The CPU Bus Unit setup can be transferred and compared between the com-
puter running the CX-FLnet and the PLC (CPU Unit or FL-net Unit).
Meaning
Normal
Service is stopped.
Section 11-2