System Setting - Extension Setting - Omron CS1W-FLN22 Operation Manual

Operating Procedures
Note

11-2-7 System Setting - Extension Setting

180
Menu
Edit - Copy row
Edit - Delete
1. Do not assign the local node in the mapping area table.
2. Enter 0 in the Node No. Field and enter the size of the local node setup
area in the Size Field for the area corresponding to that for the local node.
3. If the settings are made for only Area 1 (or Area 2), set the offset and size
for the other area to 0.
4. Select Option - Switch display - Hex. It will be possible to display and in-
put words, sizes, and addresses in hexadecimal.
5. The "offset" designation tells how much data to receive of the data sent
from a given node (i.e., which word to begin receiving from, and how many
words to receive). The number of words from the beginning of the sent data
until the beginning of the received data is called the "offset." The offset
function can be used to receive only a portion of the data sent from a given
node to enable using the Data Link Memory Areas efficiently.
6. Select Option - Switch Settings - Hex from the Main Menu. It will be pos-
sible to display and input words, sizes, and addresses in hexadecimal.
The order of link data bytes can be specified for each node according to the
needs of the connected device, eliminating the need for upper/lower byte con-
version (swapping) processing in the ladder program or user application.
Item
Local node setup
Order of send data
Other node setup
Order of send data
Function
Copy a single data row data and add as a new row.
Delete a single data row.
Content
Set the order for transferring data for local nodes. Select
sequential direction (same as the FLN02 and FLN12) or
reverse direction.
Set the order for transferring data for other nodes. Select
sequential direction (same as the FLN02 and FLN12) or
reverse direction.
Section 11-2