Omron CS1W-FLN22 Operation Manual page 250

FL-net Unit Support Software Ver. 1.6
Installation
This section explains how to install the software for setting the FL-net Unit's operating parameters.
Installation Procedure
The procedure for installing the FL-net Unit Support Software is given below. Use the special-purpose Support
Software Installer to install the software.
Note (1) Make sure the user has Administrator authority when installing the FL-net Unit Support Software in
a computer running Windows.
(2) Operations and screen displays will vary slightly according to the Windows system which is used.
(3) The FL-net Unit Support Software uses the following four setup files:
1) SETUP.EXE
2) SETUP.LST
3) FL_NET1.CAB
4) FL_NET2.CAB
When setting up from a floppy disk, store files 1 to 3 on one disk (Setup Disk 1) and file 4 on a sec-
ond disk (Setup Disk 2). When setting up from a hard disk, compact flash memory, or other memory
storage location, store files 1 to 4 in a user-specified folder.
1. Close all applications that are running.
2. Insert the Support Software's Setup Disk 1 into the drive. This operation is not required when copying setup
files from a memory storage location such as a hard disk.
3. Click the Start Button, and select Run.
4. As shown in the following diagram, specify \Setup.exe at the drive where the disk is set, and then click the
OK Button. \Setup.exe can be selected at the appropriate drive by clicking the Browse Button.
5. Depending on the Windows system being used, some of the system files may be modified for the setup, and
it may be necessary to restart Windows.
If the following message is displayed, click the OK Button. If it is not displayed, proceed to Step 7.
6. Click the Yes Button. After the computer has been restarted, the setup will be started when setup.exe is
again executed.
224
Appendix F