Omron CS1W-FLN22 Operation Manual page 177

Error Log
Error Meaning
code
0103 Resend count exceeded (send
failed)
0105 Node address setting error (send
failed)
0107 Remote node not in network (send
failed)
0108 No Unit with specified unit
address (send failed)
010B CPU Unit error (send failed)
010D Destination address not in routing
tables (send failed)
010E No routing table entry (send
failed)
010F Routing table error (send failed)
0110 Too many relay points (send
failed)
0111 Command too long (send failed)
0112 Header error (send failed)
0117 Internal buffers full; packet dis-
carded
0118 Illegal packet discarded
0119 Local node busy (send failed)
0120 Unexpected routing error
0121 No setting in IP address table;
packet discarded
0122 Service not supported in current
mode; packet discarded
0123 Internal send buffer full; packet
discarded
0124 Maximum frame size exceeded;
routing failed
021A Logic error in setting table
Detailed error code
1st byte 2nd byte
Commands
Bit 15: OFF
Bits 08 to 14: SNA
Bits 00 to 07: SA1
Responses
Bit 15: ON
Bits 08 to 14: DNA
Bits 00 to 07: DA1
00 01: Data link
table
02: Network
parameters
03: Routing
tables
04: Setup
05: CPU Bus
Unit Words
(CIO/DM)
Correction
Check transceiver at remote node. ---
Set the IP address correctly.
Check the connection to the
remote node.
Check the unit address at the
remote node.
Troubleshoot the error in the CPU
Unit using the PLC operation
manual.
Set the destination address in the
routing tables.
Set the local node, remote node,
and relay nodes in the routing
tables.
Create the routing tables correctly. ---
Reconstruct the network or cor-
rect the routing tables so that
commands are sent to within a 3-
level network range.
Check the command format and
set the correct command data.
Check the command format and
set the correct command data.
Change the network so that traffic
is not concentrated.
Check for nodes sending illegal
packets.
Change the network so that traffic
is not concentrated.
Check the routing tables.
Set the remote node in the IP
address table.
Select the IP address table or
both methods for the address con-
version method.
Change the network so that traffic
is not concentrated.
Reduce the size of the FINS mes-
sage.
Recreate the data specified by the
2nd byte of the detailed error
code.
Section 10-3
EE-
PROM
---
---
---
---
---
---
---
---
---
---
---
---
---
---
---
---
---
Saved
151