Omron CS1W-FLN22 Operation Manual page 256

FL-net Unit Support Software Ver. 1.6
Initializing
1. Select Initialize from the File Menu.
2. The system and communications settings will be initialized to their default values.
Opening
1. Select File Open from the File Menu.
2. When any file is selected, the previously-set contents of that file can be read.
Saving
1. Select Save to file from the File Menu.
2. The contents of a file can be saved by specifying the filename.
Exiting
1. Select Exit from the File Menu.
2. The FL-net Unit Support Software will be exited.
Communications Settings
(1)
(3)
(1) CPU Bus Unit Number (Default: 0)
Specify the unit number (0 to F).
Use the same setting as the number set on the rotary switch on the front panel of the FL-net Unit.
(2) Transmission Wait Timer (Default: 3,000 ms)
Specify the period of time to wait for the response to be returned (1 to 65,535 ms). If the value is too small,
communications may not be possible.
The baud rate must be taken into account, but there is normally no need to change this setting.
(3) Serial Port Number (Default: 1)
Specify the number of the serial port number to be used at the computer (for cable connection).
(4) Baud Rate (Default: 9,600 bps)
Specify the baud rate (9,600, 19,200, or 38,400 bps) for connecting to the PLC. Match the baud rate that is
set for the PLC port.
When the PLC communications port setting is for "Auto-detect Programming Device," the connection can be
made at any of the baud rate settings. The PLC automatically detects the baud rate and makes the connec-
tion.
230
(2)
(4)
Appendix F