Specifications And Configurations; System Configuration - Omron SYSMAC CS1W-CLK13 Operation Manual

Specifications and Configurations

1-2 Specifications and Configurations
1-2-1

System Configuration

Optical Bus or Optical Ring System (H-PCF Cable)
Backup power
supply (24 VDC)
A single Controller Link Network is configured as shown in the following dia-
gram.
Token-ring Mode
CS1W-CLK12-V1
Controller Link Unit
(Token-ring mode)
CS-series PLC
CS-series PLC
CS1W-CLK12-V1
Controller Link Unit
(Token-ring mode)
Token-ring Mode in CS1D System with Duplex Controller Link Units
CS1W-CLK12-V1
Controller Link Unit
(Token-ring Mode)
CS1D PLC
(Simplex System)
Backup
power supply
(24 VDC)
CS1D PLC
(Duplex System)
CS1W-CLK12-V1
Controller Link Unit
(Token-ring Mode)
Units can be used in duplex operation only when the new version-1 Controller
Link Units are mounted on a CS1D PLC. Either a CS1D Duplex System or
CS1D Simplex System allows duplex operation of Communications Units.
Controller Link Networks can include both nodes with Units used in duplex
operation (new models) and nodes without Units used in duplex operation
(new models and/or existing models) as well as CVM1 and CV-series Control-
ler Link Units.
CVM1-CLK12
Controller Link Unit
(Token-ring mode)
CVM1 or
CV-series PLC
H-PCF Optical Fiber Cable
(ring connection)
CVM1 or
CV-series PLC
CVM1-CLK12
Controller Link Unit
(Token-ring mode)
CVM1 or CV-series PLC
C C
P P
U U
H-PCF Optical Fiber Cable
(ring connection)
C C C
P P P
U U U
CS1D PLC
(Simplex System)
CS1W-CLK12-V1
Controller Link Unit
(Token-ring Mode)
Section 1-2
Computer
3G8F7-CLK12-EV1
Controller Link
PCI Support Board
(Token ring mode)
CVM1-CLK12
Controller Link Unit
(Token-ring Mode)
Computer
C C
P P
U U
3G8F7-CLK12-EV1
Controller Link
C C
PCI Support Board
P P
(Token-ring mode)
U U
13