Setting Up Tools; Selecting The Correct Operating Mode; Preparing And Measuring Tools - HEIDENHAIN TNC 320 User Manual

1.5

Setting up tools

Selecting the correct operating mode

Tools are set up in the Manual Operation mode:
Press the operating-mode key: The TNC switches
to the Manual mode of operation
Further information on this topic
Operating modes of the TNC: see "Modes of Operation",
page 67

Preparing and measuring tools

Clamp the required tools in their chucks
When measuring with an external tool presetter: Measure the
tools, note down the length and radius, or transfer them directly
to the machine through a transfer program
When measuring on the machine: store the tools in the tool
changer page 59
TNC 320 | User's Manual
HEIDENHAIN Conversational Programming | 3/2014
Setting up tools
1
1.5
57