Table of Contents
Advertisement
Tools
Operating-system
password
July 2013
Press the Copy button to save the diagnostic file in the open target folder.
There you will later find the diagnostic file, can copy it from the control (e.g.
with TNCremo) and send it by e-mail.
The folder mnt under file system is the folder that contains the HEIDENHAIN
partitions TNC, PLC and SYS.
The HeROS 5 operating system provides additional software tools that make
it possible to also open external file types and edit some of these file types.
These tools are not software tools from HEIDENHAIN. They are tools from
external suppliers. HEIDENHAIN will not provide any support or guarantee for
the proper functioning of these tools. The following tools are available:
File manager
File manager of the operating system
Mousepad
Text editor for opening and editing TXT and INI files
PDFViewer
Viewer software for opening PDF files
Ristretto
Viewer software for opening GIF, JPG, PNG and BMP files
Gnumeric
Editor for opening and editing XLS and CSV files
Firefox
Web browser for opening HTML files
If file types that are not known to the NC control software are selected in the
file manager of the control, then the operating system automatically uses the
corresponding tools to open the file types it knows. The tools themselves can
only be opened in the PLC mode of operation. Proceed as follows:
While in the Programming and Editing operating mode, press the MOD key.
Enter the code number 807 667 to switch to the PLC operating mode.
Make the taskbar at the bottom of the screen visible by moving the mouse
pointer over it.
Press the green HEIDENHAIN button to open the JH menu.
Select the Tools menu item.
Start the desired tool.
Certain accesses to or changes in the operating system are password-
protected. The code number 807667 or the PLCPASSWORD defined in the
OEM.SYS are required for these areas.
2.7 Software
173
Advertisement
Table of Contents
