Connecting The Router To A Network For Out-Of-Band Management - Juniper MX204 Hardware Manual

MX204 3D Universal Edge Router Hardware Guide

Connecting the Router to a Network for Out-of-Band Management

84
Figure 39: MX204 Front Panel Ports, LEDs and Buttons
1
16
1— Rate-selectable ports
2— MGMT
Management ( ) port
3— BITS
port with LEDs
4— USB port
5— 1PPS and 10MHz GPS input and output
ports
6— ONLINE
LED
7— SSD1 LED
8— OFFLINE button
Connecting the Router to a Network for Out-of-Band Management on page 84
Connecting the Router to a Console Device on page 85
Connecting the Router to External Clocking and Timing Devices on page 86
To connect the router to a network for out-of-band management, connect an Ethernet
cable with RJ-45 connectors to the
provided with the router.
NOTE: Use shielded CAT5e cable for the
To connect to the MGMT port on the router faceplate:
Turn off power to the management device.
1.
Plug one end of the Ethernet cable
2.
the port on the router.
MGMT
Plug the other end of the cable into the network device.
3.
Figure 40: Out-of-Band Management Cable Connector
2 3
15 14 13
9— RESET
10— SSD0
11—
Alarm (
12— OK/FAIL
13— Time of day (
14—
Console (
15— 10-Gigabit Ethernet SFP+ ports
16— PTP grandmaster clock (
port on the router. One Ethernet cable is
MGMT
CON
(Figure 40 on page 84
4 5 6 7 8
12 11 10 9
button
LED
ALM
) LED
LED
ToD ) port with LEDs
CON
) port
GM/PTP ) port
and MGMT ports on the chassis.
shows the connector) into
Copyright © 2018, Juniper Networks, Inc.