Error Messages - Ricoh MD-P2 Field Service Manual

5. System Maintenance Reference
6. Use the arrow key to turn "Bit Switch 1" and press "OK" and use the arrow key to turn bit 4 to "1
(ON)". The result should look like: 00010000. By doing this Card Save option will appear in "List/
Test Print".
7. Press the "Escape" button several times, and use arrow key to select "End" to exit SP Mode.
8. Press the "Menu" button.
9. Use the arrow key and select "List/Test Print".
5
10. Use the arrow key and select "Cardsave (ADD) or Cardsave (New).
11. To enable the newly configured settings, select "#" button and then press the "Escape" button to exit
the "List/Test Print" menu.
12. Send a job to the printer.
13. As soon as the printer receives the data, it will be stored on the SD card automatically with no print
output. Nothing is displayed on the screen indicating that a Card Save operation was successful.
14. Press the "Suspend/Resume" button and then the "Escape" button to exit Card Save mode.
15. Change the Bit Switch Settings back to the default 00000000.
16. Remove the SD card after main power switch is turned off.

Error Messages

Card Save error messages:
• Init error: A card save process (e.g. card detection, change to kernel mode) failed to initialize.
• Card not found: Card cannot be detected in the slot.
• No memory: Insufficient working memory to process the job.
• Write error: Failed to write to the card.
186