Toshiba e-STUDIO 2555C Service Manual page 69

[ 4 ] Bypass feed copying
1. Insert a paper into the bypass tray.
→ Bypass paper sensor (S16) is turned ON.
- "Ready for bypass feeding" is displayed.
→ Carriages move to the home position.
2. Press the [START] button ON
→ "Ready for bypass feeding" changes to "COPYING".
→ Exposure lamp (EXP) ON
→ Scan motor (M1) ON→Carriages-1 and -2 move forward.
→ Drum/TBU motor (M6), Paper feeding/developer unit drive motor (M2), and fuser motor (M4)
turned ON
- The drum, transfer belt, fuser unit and developer unit are driven.
3. Bypass feeding
→ Fans rotate at high speed.
→ Bypass feed clutch (CLT3) turned ON.
- The bypass feed roller is lowered.
→ Aligning operation
→ Paper reaches the registration roller.
→ After a certain period of time, the bypass feed clutch (CLT3) turned OFF.
4. Hereafter, operations (3) through (6) of "5.2.3Drawer feed copying (1st drawer paper feeding)" are
repeated.
[ 5 ] Interruption copying
1. Press the [INTERRUPT] button
→ LED "INTERRUPT" is turned ON.
→ Copying operation in progress is temporarily stopped, and the carriages-1 and -2 return to
appropriate positions.
→ "Job interrupted job 1 saved" is displayed.
→ Automatic density and reproduction ratio 100% are set. Set number remains the same.
2. Select the desired copy condition
3. After interruption copying is finished:
→ "Press interrupt to resume job 1" is displayed.
→ LED "INTERRUPT" is turned OFF by pressing the [INTERRUPT] button, and the equipment
returns to the status before the interruption.
→ "Ready to resume job 1" is displayed.
4. Press the [START] button
The copying operation before the interruption is resumed.
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2555C/3055C/3555C/4555C/5055C
3 - 29
OUTLINE OF THE MACHINE
3