Configuring Bootp On The Current Instance Of The Switch Or Server - Avaya 4000 Series Quick Start Configuration

Configuring the switch using ACLI
4. Set the default gateway IP address.
5. Save the configuration.
Variable definitions
Use the data in the following table to use the ip address command.
Table 5: ip address command
<A.B.C.D>
netmask <A.B.C.D>
Use the data in the following table to use the ip default-gateway command.
Table 6: ip default-gateway command
default-gateway <A.B.C.D>
Value of IP address ranges from 0.0.0.0 (no IP address assigned) to 255.255.255.255. For
more information on IP addressing and subnet addressing, see Configuration — IP Routing
and Multicast Avaya Ethernet Routing Switch 4000 Series (NN47205-506).
Configuring BootP on the current instance of the switch or
server
About this task
The default operational mode for BootP on the switch is BootP or DefaultIP. The switch
requests an IP address from BootP only if one is not already set from the console terminal (or
if the IP address is the default IP address 192.168.1.1).
Procedure
1. Enable Global Configuration mode in ACLI:
26 Quick Start Configuration for Avaya ERS 4000 Series
ip default-gateway <A.B.C.D>
save config
Variable
Variable
enable
configure terminal
Comments? infodev@avaya.com
Value
Set the management IP address.
Set the subnet mast IP address.
Value
Set the default gateway IP address.
November 2013