Attaching An Acl L2/L3 Configuration - Motorola WS5100 Series Reference Manual

6.5.3 Attaching an ACL L2/L3 Configuration

Use the Attach-L2/L3
To attach an interface:
1. Select Security
2. Click the Attach-L2/L3
3. Refer to the following information as displayed within the Attach tab:
Interface
IP ACL
MAC ACL
4. Select an interface and click on
5. Select an interface and click the
6. Click on Add button to add an physical or VLAN interface to the switch. For more information, see
a New ACL L2/L3 Configuration on page
6.5.3.1 Adding a New ACL L2/L3 Configuration
After creating an ACL, it can be applied to one or more interfaces. On a Layer 3 interface, it can be applied
in either an outbound or inbound direction, and only in an inbound direction on a Layer 2 interface. To add an
ACL interface to the switch:
screen to view and assign the ACL to a physical interface or VLAN.
> ACLs from the main menu tree.
tab.
The interface to which the switch is configured. It can be one of the following:
• eth1
• eth2
• vlan1 (or any additional VLANs that have been created)
• tunnel n (where n equals the name(s) of those tunnels created thus far).
Displays the IP ACL configured as the inbound IP for the layer 2 or layer 3 interface.
Displays the MAC ACL to be configured as the MAC IP for the layer 2 interface.
Edit to modify the ACL interface, IP ACL and MAC ACL values.
Delete button to delete the interface configuration from the switch.
6-25.
6-25
Switch Security
Adding