Editing A Mst Port Configuration - Motorola WS5100 Series Reference Manual

4-122 WS5100 Series Switch System Reference Guide
Admin Edge Port
Oper Edge Port
Admin Point-to-Point
Oper Point-to-Point
3. Select an Id and click the

4.10.3.1 Editing a MST Port Configuration

To edit and reconfigure MSTP Port parameters.
1. Select a row from the port table and click the
The following MST Port parameters can be reconfigured.
Port Index
Admin MAC Enable
A green checkmark defines the listed index enabled as an Admin Edge Port, and a
red "X" defines the listed index as not being an Admin Edge Port.
An oper edge port transitions MST data into a forwarding state. Enable it only on
ports that connect to a single location.
A green checkmark defines the listed index enabled as an Oper Edge Port, and a red
"X" defines the listed index as not being an Oper Edge Port.
Displays the point-to-point status as ForceTrue or ForceFalse. ForceTrue indicates
this port should be treated as connected to a point-to-point link. ForceFalse
indicates this port should be treated as having a shared connection.
Displays whether the listed port index is configured to connect to another port
through a point-to-point link. If enabled, the port index becomes a designated port.
The designated port negotiates a rapid transition with the other port using a
proposal-agreement handshake for a loop-free topology. A green checkmark
defines the listed index as supporting point-to-point, and a red "X" defines the
listed index as having point-to-point disabled.
Edit button to revise the selected MST port configuration.
Displays the read-only Port Index.
Displays the status of the Admin MAC Enable. A green check mark indicates the
status as enabled and a red X indicates the status as disabled.
Edit button.