Motorola WS5100 Series Reference Manual page 89

3. The read-only
routing between VLANs, use the
The following details display in the table:
Destination Subnet
Subnet Mask
Gateway Address
Interface
Protocol
Active
4. Select an entry and click the
5. Click the Add
on page 4-7.
6. Click Enable
4.2.2.1 Adding a New Static Route
Use the Add screen to add a new destination subnet, subnet mask and gateway for routing packets to a
defined destination. Use the screen when an existing destination subnet does not meet the needs of the
network.
To add a new static route:
IP Forwarding tab displays the current status between VLANs. To toggle the status of
Enable/Disable
Displays the mask used for destination subnet entries. The Subnet Mask is the IP
mask used to divide internet addresses into blocks (known as subnets). A value of
255.255.255.0 will support 256 IP addresses.
Displays the mask used for destination subnet entries. The Subnet Mask is the IP
mask used to divide internet addresses into blocks (known as subnets). A value of
255.255.255.0 will support 256 IP addresses.
Displays the IP address of the Gateway used to route the packets to the specified
destination subnet. Do not set the gateway address to any VLAN interface used
by the switch.
Displays the interface name with which the destination subnet entries are
attached.
Displays the name of the routing protocol with which this route was obtained.
Possible values are:
• Static — Routes are statically added by the operator.
• DHCP — Routes obtained from the DHCP server.
• Connected — Routes automatically installed by the switch for directly
connected networks based on interface IP addresses.
• Kernel/ ICMP — Routes added as a result of receiving an ICMP redirect from
an intermediate router.
When IP Forwarding is enabled for the selected subnet, a green check displays in
the Active column. A red X defines the subnet as disabled.
Delete button to remove the selected entry from the IP forwarding table.
button to create a new static route. For more information, see
(to allow) or Disable (to deny) routing between VLANs.
options located at the bottom of the screen.
Adding a New Static Route
4-7
Network Setup