1. Select an image from the table in the Firmware screen.
2. Click the
Global Settings
3. Select the
Enable Image Failover
module fails to load the selected version successfully after 2 reboot attempts.
4. Refer to the
Status
"SET/GET" operation from the applet. The Status field displays error messages if something goes wrong
in the transaction between the applet and the switch.
5. Click
OK
to save and add the changes to the running configuration and close the dialog.
3.4.3 Updating the Switch Firmware
Use the
Update
screen to update the firmware version currently used by the switch.
NOTE: When performing a firmware update using the switch CLI, use the following
syntax (specific to FTP) ftp://username:password@ipaddress:port/path/filename.
If using TFTP, use tftp://ipaddress/path/filename.
1. Select an image from the table in the Firmware screen.
2. Click the
Update Firmware
3. Use the
From
drop-down menu to specify the location from which the file is sent.
4. Enter the name of the file containing the firmware update in the
This is the file that will append the file currently in use.
button.
checkbox to load an alternative firmware version if the WLAN
field for the current state of the requests made from the applet. Requests are any
button.
Switch Information
File
text field.
3-23