Motorola WS5100 Series Reference Manual page 394

7-28 WS5100 Series Switch System Reference Guide
3. Click the Add
4. Configure the following Radius Server attributes:
Radius Server IP
Address
Radius Server Port
Number of retries to
communicate with
Radius Server
Time to wait for
Radius Server to reply
Encryption key shared
with Radius Server
5. Refer to the
messages if something goes wrong in the transaction between the applet and the switch.
6. Click on OK
7. Click Cancel
button at the bottom of the screen.
Provide the IP address of the external Radius server. Ensure this address is a valid
IP address and not a DNS name.
Enter the TCP/IP port number for the Radius Server. The port range available for
assignment is from 1 - 65535.
Enter the maximum number of times for the switch to retransmit a Radius Server
frame before it times out the authentication session. The available range is
between 0 - 100.
Enter the maximum number of times the switch can retransmit a Radius Server
frame before it times out of the authentication session. The available range is
between 0 - 100.
Enter the encryption key the switch and Radius Server share and must validate
before the user based authentication provided by the Radius Server can be
initiated.
Status field for the current state of the requests made from applet. This field displays error
to complete the addition of the Radius Server.
to revert back to the last saved configuration without saving any of your changes.