Motorola WS5100 Series Reference Manual page 222

5-14 WS5100 Series Switch System Reference Guide
2. Click the Relay
3. Refer to the Interfaces field for the names of the interfaces available to route information between the
DHCP Server and DHCP clients. If this information is insufficient, consider creating a new IP pool or edit
an existing pool.
4. Refer to the
these address are not in conflict with the addresses used to route data between the DHCP Server and
client.
NOTE: The gateway address should not be set to a VLAN interface used by the switch.
5. Click the Edit
information that can be modified for the DHCP relay.
6. To delete an existing DHCP pool from the list of those available to the switch, highlight the pool from
within the Network Pool field and click the
NOTE: The interface VLAN and gateway interface should have their IP addresses set. The
interface VLAN and gateway interface should not have DHCP client or DHCP Server
enabled. DHCP packets cannot be relayed to an onboard DHCP Server. The interface VLAN
and gateway interface cannot be the same.
7. Click the Add
a. Use the
added to the switch, the number of interfaces available grows.
b. Add Servers
drop-down menu associated with each Server to supply the interface used to route data. The
gateway address should not be set to any VLAN interface used by the switch.
c. Click OK
tab.
Gateway Information field for DHCP Server and Gateway Interface IP addresses. Ensure
button to modify the properties displayed on an existing DHCP pool. Refer to step 7 for the
button to create a new DHCP pool.
Interface drop-down menu to assign the interface used for the DHCP relay. As VLANs are
as needed to supply DHCP relay resources. As Servers are added, use the
to save and add the changes to the running configuration and close the dialog.
Delete button.
Gateway