Motorola WS5100 Series Reference Manual page 76

3-30 WS5100 Series Switch System Reference Guide
3. Refer to the
cluster file updates.
Enable
IP Address
User ID
File Name (With
Path)
Protocol
Password
4. Refer to the
enabled, the located (updated) switch firmware is used with the switch the next time the switch boots.
Enable
IP Address
User ID
File Name (With
Path)
Protocol
Password
Version
5. Select the Start Update
configuration or firmware facilities.
6. Click the Apply
7. Click the Revert
Redundancy Configuration
Select the Enable checkbox to allow an automatic cluster file update when a new
(updated) file is detected (upon the boot of the switch) at the specified IP address.
Define the IP address
is detected when the switch is booted it will be uploaded to the switch and used
upon the next boot of the switch.
Enter the User ID required to access the FTP or TFTP server.
Provide the complete and accurate path to the location of the cluster files on the
server. This path must be accurate to ensure the most recent file is retrieved.
Use the Protocol drop-down menu to specify the
resident switch FLASH
the default setting.
Enter the password required to access the server.
Firmware field to enable and define the configuration for automatic firmware updates. If
Select the Enable checkbox to allow an automatic firmware update when a new
(updated) version is detected (upon the boot of the switch) at the specified IP
address.
Define the IP address
version is detected when the switch is booted it will be uploaded to the switch
and used upon the next boot of the switch.
Enter the User ID required to access the FTP or TFTP server.
Provide the complete and accurate path to the location of the firmware files on the
server. This path must be accurate to ensure the file is retrieved.
Use the Protocol drop-down menu to specify the
resident switch FLASH
the default setting.
Enter the password required to access the server.
Provide the target firmware version to ensure the switch is upgrading to the
intended baseline.
button to begin the file updates for the enabled switch configuration, cluster
button to save the changes to the configuration.
button to revert back to the last saved configuration.
field to enable and define the configuration for automatic
of the server where the cluster files reside. If a new version
FTP, TFTP, HTTP, SFTP
medium used for the file update from the server. FLASH is
of the server where the firmware files reside. If a new
FTP, TFTP, HTTP, SFTP
medium used for the file update from the server. FLASH is
or
or